You will need to locate a port on passenger side of the intake manifold underneath the intercooler.
MINI COOPER S BOOST GAUGE KIT INSTALL
Install T-Fitting for the Boost/Vacuum Lineġ. Proceed with the wiring installation instructions enclosed with your gauges. It helps to have an assistant let you know when you’ve pulled enough of the wires through.ġ0. Carefully pull the wires through, being mindful of leaving a bit of slack in the wires. Look up into the dash and locate where the wires are coming into the vehicle. This will unsnap the lower panel along the top and it will pivot down on hinges.ĩ. Place your fingers in the gap under steering column and pull/push down.
MINI COOPER S BOOST GAUGE KIT DRIVERS
Back inside the car, the firewall entry point can be accessed by dropping the drivers side lower dash panel. Utilize a tool such as an awl to poke a hole through the rubber firewall plug, being careful that you do not damage anything on the other side.Ĩ. Zip-tie the wires into place as you go so that they stay away from hot or rotating components in the engine compartment.ħ. Attach your wires to the oil pressure sending unit and strategically route them along existing OEM wires until you end up at the firewall plug behind the brake booster. If you are not installing a sending unit/sensor at this time, install the included ⅛ NPT plug.Ħ. Install into the ⅛ NPT port on the side of the CravenSpeed Tapless Oil Adapter and tighten. Take the oil pressure sending unit included with your gauge (if applicable), and apply thread sealant to its threads. Install this unit back into the oil pressure sensor port on the engine block and tighten.ĥ. Install OEM oil pressure sensor onto the CravenSpeed Tapless Oil Adapter and then apply some teflon tape/thread sealant to the threads of the CravenSpeed Tapless Oil Adapter.Ĥ.
Clean any residual oil off of the OEM oil pressure sensor then apply some teflon tape or thread sealant its threads. There’s not a lot of room to perform this step, so you may need to experiment with a few different tool configurations to remove the sensor.ģ. Utilizing a 27mm deep well socket, remove the OEM oil pressure sensor and set aside. Remove the red plastic locking tab/clip from the wiring plug and disconnect the plug.Ģ. First you will need to locate the stock oil pressure sensor that is located underneath and slightly to the right of the oil filter. Determine the routing for the Boost/Vacuum tubing and/or wiring for Oil Pressure, Water Pressure, Oil Temp or Water Temp gauge(s)ġ. Preparation for Installation of Sender(s)ġ.
0 kommentar(er)
